Codeofchina.com is in charge of this English translation. In case of any doubt about the English translation, the Chinese original shall be considered authoritative.
This standard is developed in accordance with the rules given in GB/T 1.1-2009.
This standard replaces GB/T 22864-2009 Towel.
The following main technical changes have been made with respect to GB/T 22864-2009:
——The scope of this standard is modified (see Clause 1; Clause 1 of Edition 2009);
——The “Normative references” is modified (see Clause 2);
——The requirement of "in accordance with GB 31701" is added (see 4.1);
——The assessment requirements for water extract within superior towels are added (see 4.2);
——The provision that the maximum force may not be assessed for small towels is added (see footnote a of Table 1);
——The allowable degree of appearance quality index is modified (see 4.3; 4.4 of Edition 2009);
——The appearance quality requirements for the thread end of four-sided seam are added (see 4.3);
——The test method for weight deviation rate is modified (see 5.1.1; 6.1.1 of Edition 2009);
——The sampling position for water absorption test is modified (see 5.1.3; 6.1.3 of Edition 2009);
——The test method for fiber content is modified (see 5.1.5; 6.1.5 of Edition 2009);
——The test method for water extract within towel is added (see 5.1.9);
——The contents of product instructions are modified (see 7.1; 8.1 of Edition 2009).
——Annex A is changed from normative to informative (see Annex A; Annex A of Edition 2009).
This standard was proposed by China National Textile and Apparel Council.
This standard is under the jurisdiction of the National Technical Committee on Household Textiles of Standardization Administration of China (SAC/TC 302).
The previous edition of this standard is as follows:
——GB/T 22864-2009.
Towels
1 Scope
This standard specifies the terms and definitions, requirements, test methods, inspection rules, marking, packaging, transportation and storage of towel products.
It is applicable to all kinds of woven towel products with textile fiber as raw material.
It is not applicable to microfiber towels and disposable towels.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
GB/T 250 Textiles - Tests for colour fastness - Grey scale for assessing change in colour
GB/T 2910 (All parts) Textiles - Quantitative chemical analysis
GB/T 3920 Textiles - Tests for colour fastness - Colour fastness to rubbing
GB/T 3921-2008 Textiles - Tests for colour fastness - Colour fastness to washing with soap or soap and soda
GB/T 3923.1 Textiles - Tensile properties of fabrics - Part 1: Determination of maximum force and elongation at maximum force using the strip method
GB/T 4841.3 Colour cards of standard depths for dyeing with dyestuffs 2/1, 1/3, 1/6, 1/12, 1/25
GB/T 5296.4 Instructions for use of products of consumer interest - Part 4: Textiles and apparel
GB 6529 Textiles - Standard atmospheres for conditioning and testing
GB/T 7069 Textiles - Testing method for colour fastness to bleaching: Hypochlorite
GB/T 8170 Rules of rounding off for numerical values & expression and judgment of limiting values
GB 18401 National general safety technical code for textile products
GB/T 22798-2019 Test method for fiber shedding of towel products
GB/T 22799-2019 Test method for absorption of towel products
GB/T 27754 Home textiles - Limit of water extraction material within towel
GB/T 29862 Textiles - Identification of fiber content
GB 31701 Safety technical code for infants and children textile products
FZ/T 01057 (All parts) Test method for identification of textile fibres
3 Terms and definitions
For the purposes of this document, the following terms and definitions apply.
3.1
towels
fabric using textile fiber as raw material, and the surface presents loop or terry, which is used for washing, keeping warm and decorating in daily life
Examples: Square towel, face towel, bath towel, towel quilt, etc.
3.2
terry towels
towels with surface loop subjecting to cutting process
4 Requirements
4.1 The basic safety technical requirements of products shall be in accordance with GB 18401, and the products for infants and children shall be in accordance with GB 31701.
4.2 The inherent quality of product includes weight deviation rate, maximum force, water absorption, fiber falling off rate, fiber content deviation, colour fastness (to washing with soap or soap and soda, to rubbing, to bleaching with chlorine) and water extract within towel, and the inherent quality indexes shall meet the requirements of Table 1.
?
Table 1 Inherent quality indexes
S.N. Assessment item Superior product First-grade product Acceptable
product
1 Weight deviation rate (standard atmosphere)/% ±2.5 ≥-3.5 ≥-4.5
2 Maximum force a/N ≥ 220 180
3 Water absorption b/s ≤ 10 20 30
4 Fiber falling off rate b/ % ≤ 0.5 1.5 2.0
5 Fiber content deviation/ % As per GB/T 29862
6 Colour fastness to washing with soap or soap and soda/ grade ≥ Discoloration 4 3-4 3
Staining 4 3-4 3
Colour fastness to rubbing c/grade
≥ Dry rubbing 4 3-4 3
Wet rubbing 3-4 3 3 (pigment printing, dark colour 2-3)
Colour fastness to bleaching with chlorine d/ grade ≥ Discoloration 4 3-4 3
7 Water extract within towel As per GB/T 27754 - -
Note: The weight deviation rate is used for batch delivery.
a For towels too small in size to be sampled normally, the maximum force may not be assessed.
b The water absorption and fiber falling off rate of towel quilt are not assessed.
c If the colour fastness to rubbing is excellent, the dark colour of first-grade products can be reduced by half a grade. According to GB/T 4841.3, the colour with depth >1/12 standard depth is regarded as deep colour and that with depth ≤1/12 standard depth is regarded as light colour.
d The colour fastness to chlorine bleaching is ignored for products that cannot be bleached by chlorine.
4.3 The appearance quality of products covers the specification/dimension deviation rate, defects, sewing quality and ironing quality, and the appearance quality indexes shall meet the requirements in Table 2.
Foreword i
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
5 Test methods
6 Inspection rules
7 Marking, packaging, transportation and storage
Annex A (Informative) Requirements for towel defects
