YY/T 1472.1-2016 Thoracic minimally invasive instruments - Part 1: Dual pivot surgical clamps
1 Scope
This part of YY/T 1472 specifies the classification, requirements, test methods, inspection rules, marking and instructions for use, packaging, transportation and storage requirements for dual pivot surgical clamps.
This part is applicable to dual pivot surgical clamps (hereinafter referred to as clamps) for mini-thoractomy:
——Minimally invasive tissue clamp, for clamping tissues and organs, such as lung lobes and lymph nodes;
——Minimally invasive separation ligation clamp, for separating target organs, such as blood vessels and tissues;
——Minimally invasive vascular clamp, for clamping and blocking blood vessels;
——Minimally invasive needle clamp, for clamping a suture needle.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
GB/T 4237-2015 Hot rolled stainless steel plate, sheet and strip
GB/T 4240-2009 Stainless steel wires
GB/T 4340.1-2009 Metallic materials - Vickers hardness test - Part 1: Test method
GB 7543-2006 Single-use sterile rubber surgical gloves
GB/T 8938-2008 Typewriting paper
GB/T 16886.1-2011 Biological evaluation of medical devices - Part 1: Evaluation and testing within a risk management process
GB 19790.2-2005 Disposable chopsticks - Part 2: Bamboo chopsticks
BB/T 0014-2011 Grip bag
YY/T 0031-2008 Silicone tubes and elastomeric parts for infusion and transfusion
YY/T 0149-2006 Medical instruments of stainless steel - Test methods of corrosion resistance
YY 0167-2005 Non-absorbable surgical suture
YY/T 0173.4-2005 Surgical instruments - Teeth, serration, ratchet and elliptoid ring
YY/T 1052-2004 Marking requirements for surgical instruments
3 Product classification
3.1 Structural type
3.1.1 Clamps include minimally invasive tissue clamp, minimally invasive separation ligation clamp, minimally invasive vascular clamp and minimally invasive needle clamp (hereinafter referred to as tissue clamp, separation ligation clamp, vascular clamp and needle clamp).
3.1.2 A clamp is mainly composed of clamp head, sliding rod, fixed rod, handle, box joint shaft for handle joint and box joint shaft for clamp head joint. The handles are classified into two types: ring handles (with or without locking teeth) and spring handles (with locking teeth), as shown in Figure 1. The clamp heads may be made to be straight, curved or 90° curved, as shown in Figure 2. The working face of a clamp may be made to be toothless, toothed or with reticulated teeth, as shown in Table 1.
The clamp structure may also be designed and determined by the manufacturer itself.
?
Foreword II
Introduction III
1 Scope
2 Normative references
3 Product classification
4 Requirements
5 Test methods
6 Marking and instructions for use
7 Packaging, transportation and storage
Annex A (Normative) Clamping performance test for vascular clamps
Annex B (Normative) Clamping and blocking performance test for vascular clamps
