1 Scope
This Standard specifies functional requirements and design principles for the emergency stop function on machinery, independent of the type of energy used to control the function.
This Standard is applicable to all machinery except for:
— Machines in which the provision of emergency stop would not lessen the risk;
— Hand-held portable machines and hand-guided machines.
This Standard does not deal with functions such as reversal or limitation of motion, deflection, shielding, braking or disconnecting, which can be part of the emergency stop function.
2 Normative References
The following Standards contain provisions which, through reference in this text, constitute provisions of this Standard. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this Part are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies.
Foreword II
Introduction III
1 Scope
2 Normative References
3 Terms and Definitions
4 Safety Requirements
4.1 General requirements
4.2 Electrical emergency stop equipment requirements
4.3 Operating conditions, environmental influences
4.4 Emergency stop device
4.5 Use of wires or ropes as actuators
Bibliography
GB 16754-2008 引用如下標準：
* IEC 60204-1:2005 Safety of Machinery - Electrical Equipment of Machines - Part 1: General Requirements * IEC 60947-5-5:2005 Low-voltage Switchgear and Controlgear - Part 5-5: Control Circuit Devices and Switching Elements - Electrical Emergency Stop Device with Mechanical Latching Function * IEC 60417-DB:2002 Graphical Symbols for Use on Equipment (on-line database)
