1 Scope
This standard specifies the technical requirements and test methods for WCDMA/GSM (GPRS) dual mode digital mobile user equipment (UE) in terms of service, function, RF performance, protocol performance, network compatibility and the like.
This standard is applicable to WCDMA/GSM (GPRS) dual mode digital mobile user equipment (phase 4) of WCDMA system.
2 Normative References
The following normative documents contain provisions which, through reference in this text, constitute provisions of this standard. For dated references, subsequent amendments (excluding corrections) to, or revisions, of any of these publications do not apply. However, parties to agreements based on this part are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition applies.
YD/T 1214-2006 Technical Requirement of 900/1800MHz TDMA Digital Cellular Mobile Telecommunication Network General Packet Radio Service (GPRS) Equipment: Mobile Stations
YD/T 1215-2006 Testing Methods of 900/1800MHz TDMA Digital Cellular Mobile Telecommunication Network General Packet Radio Service (GPRS) Equipment: Mobile Stations
YD/T 1844-2009 Technical Requirement and Test Method of WCDMA/GSM(GPRS) Dual Mode Digital Mobile User Equipment (Phase 3)
YD/T 2217-2011 Technical Requirements for 2GHz WCDMA Digital Cellular Mobile Communication Network User Equipment (Phase 4) - High Speed Packet Access (HSPA)
Test Method for 2GHz WCDMA Digital Cellular Mobile Communication Network User Equipment (Phase 4) - Part 1: Basic Functions, Services and Performance Test of High Speed Packet Access (HSPA)
Test Method for 2GHz WCDMA Digital Cellular Mobile Communication Network User Equipment (Phase 4) - Part 2: Network Compatibility of High Speed Packet Access (HSPA)
3GPP TS 25.331 Radio Resource Control (RRC): Protocol Specification
3GPP TS 34.123-1 User Equipment (UE) Conformance Specification; Part 1: Protocol Conformance Specification
3GPP TS 51.010-1 Digital Cellular Telecommunications System (Phase 2+); Mobile Station (MS) Conformance Specification; Part 1: Conformance Specification
3 Abbreviations and Symbols
For the purposes of this standard, the following abbreviations and symbols apply.
3.1 Abbreviations
ARFCN Absolute Radio ARFCN Channel Number
AWGN Additive White Gaussian Noise
BCCH Broadcast Control Channel
BSIC Base Station Identity Code
CFN Connection Frame Number
CPICH Common Pilot Channel
DCCH Dedicated Control Channel
DL Downlink
DRX Discontinuous Reception
DTCH Dedicated Trafic Channel
FDD Frequency Division Duplexing
GPRS General Packet Radio Service
GSM Global System for Mobile communications
HCS Hierarchical Cell Structure
HPLMN Home Public Land Mobile Network
HSUPA High Speed Uplink Packet Access
IE Information Elements
OPLMN Operator controlled PLMN
OCNS Orthogonal Channel Noise Simulator
PCCPCH Primary Common Control Physical Channel
PLMN Public Land Mobile Network
PICH Pilot Channel
RACH Random Access Channel
RAT Radio Access Technology
RF Radio Frequency
RLC Radio Link Control
RRC Radio Resource Control
RSCP Received Signal Code Power
RSSI Received Signal Strength Indicator
SCH Synchronisation Channel
SIM Subscriber Identity Module
UE User Equipment
UL Uplink
UPLMN User controlled PLMN
USIM Universal Subscriber Identity Module
UTRA UMTS Terrestrial Radio Access
UTRAN Universal Terrestrial Radio Access Network
WCDMA Wideband Code Division Multiple Access
3.2 Symbols
Foreword IV
1 Scope
2 Normative References
3 Abbreviations and Symbols
3.1 Abbreviations
3.2 Symbols
4 General Requirements
5 Technical Requirements
5.1 Service and Function Requirements
5.2 RF Performance Requirements
5.3 Protocol Performance from WCDMA to GSM
5.4 Protocol Performance from GSM to WCDMA
6 Service and Function Tests
7 RF Performance Tests
7.1 General
7.2 RF Performance of the Dual Mode UE
8 Protocol Performance Test from WCDMA to GSM
8.1 General
8.2 Correct Selection of PLMN and Corresponding RAT Combination
8.3 Correct Selection of HPLMN and Corresponding RAT Combination: Automatic Mode
8.4 Correct Selection of PLMN and Corresponding RAT Combination: Automatic Mode
8.5 Correct Selection of OPLMN and Corresponding RAT Combination: Automatic Mode
8.6 Correct Selection of Other HPLMN and Corresponding Access Technology Combination: Automatic Mode
8.7 UTRAN to GSM Cell Reselection in Case of the Cell is Barred or S<0
8.8 Cell Selection from GSM to UTRAN in Case the Cell is Barred or C1<0
8.9 Timing Requirements for GSM to UTRAN Cell Reselection
8.10 RRC Connection Establishment: with Establishment Request Rejected, Interratlnfo Set to Gsm, and Selection to the Specified System Failed.
8.11 Successful Voice Service Handover from UTRAN to GSM
8.12 Inter-system Handover with the Same Data Rate from UTRAN to GSM
8.13 Inter-system Handover with the Required Data Rate from UTRAN to GSM
8.14 Inter-system Handover from UTRAN to GSM in the Phase of Call Establishment
8.15 Failed Voice Service Handover from UTRAN to GSM
8.16 Inter-system Voice Service Handover from UTRAN to GSM Fails (with Physical Layer Failing to Synchronize)
8.17 Inter-system Voice Service Handover from UTRAN to GSM Fails (Caused by Unsupported Configuration)
8.18 Inter-system Voice Service Handover from UTRAN to GSM fails (with Physical Layer Failing and Failing in Restoring)
8.19 RRC Requirements During Successful Handover During the Call Establishment from UTRAN to GSM
8.20 Handover from UTRAN to GSM with CS and PS Domain Services Performed Simultaneously (with TBF Successfully Established)
8.21 Cell Reselection from UTRAN to GPRS While the Cell Is Barred or S<0 (UE Is In CELL_FACH State)
8.22 Cell Reselection from UTRAN to GPRS Fails, and Cell Level Changes (UE Is In CELL_FACH State)
8.23 Cell Reselection from UTRAN to GPRS Succeeds, and the Value of the Parameter RAU-Qoffset Changes (UE Is In CELL_FACH State)
8.24 Cell Change Command Between Systems with Different Radio Access Standards from UTRAN to GPRS (UE Is In CELL_DCH State)
8.25 CellChange Command Between Systems with Different Radio Access Standards from UTRAN to GPRS, with Physical Channel Failing and Failing in Returning (UE Is In CELL_DCH State)
8.26 Cell Change Command Between Systems with Different Radio Access Standards from UTRAN to GPRS Succeeds (UE Is In CELL_DCH State and HS-DSCH Reception Terminates)
8.27 Cell Change Command Between Systems with Different Radio Access Standards from UTRAN to GPRS, with Physical Channel Failing (UE Is In CELL_DCH State)
8.28 Cell Change Command Between Systems with Different Radio Access Standards from UTRAN to GPRS Succeeds Assisted by Network (UE Is In CELL_DCH State)
8.29 Cell Change Command Between Systems with Different Radio Access Standards from UTRAN to GPRS Succeeds Assisted by Network with no Valid SI (UE Is In CELL_DCH State)
8.30 Cell Change Command Between Systems with Different Access Standards from UTRAN to GPRS Succeeds (UE Is In CELL_DCH State and E-DCH Transmission Terminates)
8.31 Measurement Control and Measurement Report: Inter-RAT Measurement in CELL_DCH State
8.32 Measurement Control and Measurement Report: Measurements between different Radio Access Standards, Event 3a
8.33 Measurement Control and Measurement Report: Measurements Between Different Radio Access Standards, Event 3b
8.34 Measurement Control and Measurement Report: Measurements Between Different Radio Access Standards, Event 3c
8.35 Measurement Control and Measurement Report: Measurements Between Different Radio Access Standards, Event 3d
8.36 Measurement Control and Measurement Report: Measurements Between Different Radio Access Standards, Event 3c, with Sparse Compressed Mode Used in CELL_DCH State
8.37 Measurement Control and Measurement Report: (FDD) Combination of Measurements between Different Frequencies (Event 2b) and Measurements Between Different Access Standards (Event 3a)
8.38 GPRS Mobility Management (GMM) READY Timer Processing
8.39 UTRAN to GSM Cell Reselection Using SIB18 (Optional)
9 Protocol Performance Test from GSM to WCDMA
10 Network Compatibility Test
Bibliography
