Characteristics of non-metal reinforcement for optical fiber cables - Part 3: Aramid fiber reinforced plastic rods
1 Scope
This part specifies the designation, requirements and test methods of aramid fiber reinforced plastic (hereinafter referred to as KFRP) rods, a kind of non-metal reinforcement for optical fiber cables.
This part is applicable to KFRP rods, a kind of non-metal reinforcement for optical fiber cables.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced documents (including any amendments) applies.
GB/T 4909.2 Test methods for bare wires - Part 2: Measurement of dimensions
GB/T 13096-2008 Test method for mechanical properties of pultruded glass fiber reinforced plastic rods
YD/T 1181.1-2002 Characteristics of non-metal reinforcement used for optical cable - Part 1: Glass fiber reinforced plastic rods
YD/T 1181.2 Characteristics of non-metal reinforcement for optical fiber cables - Part 2: Aramid yarns
3 Designation
The composition of product designation is shown in Figure 1. In the designation, the diameter is expressed in millimeters (mm), and the body diameter and coating diameter are only accurate to one decimal place.
Foreword i
1 Scope
2 Normative references
3 Designation
4 Requirements
5 Test methods
