1 Scope
This standard specifies two methods for the determination of solvent extract from rubber, which are Method B, a rapid extraction method, and Method A, which is for use in cases of dispute.
This standard is applicable to raw rubbers, both natural and synthetic, their mixed compound and vulcanized rubber.
2 Normative references
The following normative documents contain provisions which, through reference in this text, constitute provisions of this standard. For dated references, subsequent amendments (excluding corrections), or revisions, of any of these publications do not apply to this standard. However parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition applies.
GB/T 5576 Rubbers and Latices - Nomenclature (GB/T 5576-1997, idt ISO 1629:1987)
GB/T 15340 Rubber, raw natural and raw synthetic - Sampling and further preparative procedures (GB/T 15340-1994, idt ISO 1795:1992)
GB/T 17783 Rubber, vulcanized - Preparation of samples and test pieces - Chemical tests (GB/T 17783-1999, idt ISO 4661-2:1987)
ISO 383:1976 Laboratory glassware - Interchangeable conical ground joints
3 Principle
3.1 Method A
Extraction of an individual weighed test portion of the rubber is carried out in a Soxhlet-type apparatus with the appropriate solvent. The solvent is then removed from the extract solution by distillation or evaporation, followed by drying and weighing of the residue.
Foreword II
1 Scope
2 Normative references
3 Principle
4 Requirements for the use of solvents
5 Reagents
6 Apparatus
7 Sampling
8 Test procedure
9 Results
10 Test report
