標準編號:	GB/T 17669.3-1999
中文名稱:	建筑石膏 力學性能的測定
英文名稱:	Gypsum plasters - Determination of mechanical properties
中標分類:	Q62    石膏制品
行業分類:	GB    國家標準
ICS分類:	91.100.10 91.100.10    水泥、石膏、石灰、砂漿 91.100.10
發布機構:	中華人民共和國國家質量監督檢驗檢疫總局
發布日期:	1999-2-8
實施日期:	1999-8-1
標準狀態:	valid
翻譯語言:	英文
文件格式:	PDF
中文字符數:	6000 字
翻譯價格(元):	460.0
交付時間:	付款后 1 個工作日

GB/T 17669.3-1999 Gypsum plasters -Determination of mechanical properties 1 Scope This standard specifies methods for determining flexural strength, compressive strength and hardness of gypsum plasters. This standard is applicable to gypsum plasters requiring for their use only the addition of water. 2 Normative references The following standards contain provision which, through reference in this standard, constitute provisions of this standard. At the time of publication, all editions listed were valid. All standards are subject to revision, and parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. GB/T 17669.1-1999 General test conditions for gypsum plasters GB/T 17669.4-1999 Gypsum plasters - Determination of physical properties of pure paste JC/T 724-1982 (1996) Apparatus for physical test of cement Electrically driven flexure testing device JC/T 725-1982 (1996) Apparatus for physical test of cement Compression jig JC/T 726-1982 (1996) Apparatus for physical test of cement Mould for cement mortars 3 Test conditions Test conditions shall meet those specified in GB/T 17669.1. 4 Test pieces 4.1 Sample treatment Process the powder sample according to the requirements of GB/T 17669.1. 4.2 Apparatus for test pieces 4.2.1 Electronic scale with a sensitivity of 1g. 4.2.2 Molding die shall meet the requirements of JC/T 726. 4.2.3 Mixing container shall meet the requirements of GB/T 17669.1. 4.2.4 Mixing spatula consists of three oval rings bent from stainless steel wires, with a wire diameter of φ1 to φ2 mm and a ring length of approximately 100mm. 4.3 Preparation of test pieces The amount of gypsum plasters mixed and prepared in one batch shall be sufficient to fill the molds for three test pieces. The volume of paste necessary, taking losses into account, is 950mL. Using the standard consistency water consumption, the amount of gypsum plasters and water to be added can be calculated using Equations (1) and (2).

Foreword I ISO foreword III 1 Scope 2 Normative references 3 Test conditions 4 Test pieces 5 Determination of flexural strength 6 Determination of compressive strength 7 Determination of hardness 8 Test report